HY DY13 100W Co2 Laser Power Supply For RECI Z2 W2 S2 Co2 Laser Tube Engraving
HY-DY13 100W Co2 Laser Power Supply For RECI Z2/W2/S2 Co2 Laser Tube Engraving / Cutting Machine DY Series
silicone, smooth. Thank you seller, I recommend...
17 days to Omsk with a track. Quality is normal, steel cutter. True in Leroy the same 160r. worth it... nevertheless it's too late...
he patiently lay a long time well, all the same the actual order came even no more hoped for him
It arrived quickly (3 weeks) to the office comfortably, if you plan to repair rapid order. The result is much better than smearing with a soap finger))
Arrived very quickly. With small diameters is not so simple. Fundamentally, all the same under the standard homemade wine and beer. Itself will not cut, of course. We must play and learn.
HY-DY13 100W Co2 Laser Power Supply For RECI Z2/W2/S2 Co2 Laser Tube Engraving / Cutting Machine DY Series
Features:
1. This power supply is specially designed for RECI Z2/S2/Z2 (90-100W) Special laser tube. The power supply makes laser tube output larger and more stable.
2. Quick response speed and effect,high performance,large cutting power,it also can prolong laser tube service life.
3. Easy control: the start and stop of laser can be easily controlled by TTL level.
4. The power supply has output open circuit protection.
5. The power supply has TTL signal indication, water through signal indication and laser output indication.
6. This power supply has the Buttonto test output laser manually.
7. Application: Sculpture and cut acrylic,fabric,double color sheet and rubber etc.
Tips:
1.Laser Tube connection: (Refer to Power supply and laser Device\'s connection Diagram) High voltage terminal of HY-DY10 power supply should be connected to the positive pole of CO2 laser device. Current circuit of the power supply shall be connected to negative pole (laser output terminal) of laser device, through an ampere meter or directly.
2.Connection of control signal( Refer to Power supply and control board\'s connection Diagram) The control signal shall be reliably connected to control terminal of the power supply HY-DY10,after connecting the DAC output signal and TTL signal of external computer with the power supply, the laser device shall work as expected. If the laser lamp can not work properly, should check the control signal whether correct or not(include check the voltage specification and logic),if use PWM control as power control,make sure f≥20KHz,Amplitude (peak value) ≤5V,Check and protection switch WP connection is correct at same time.
3.Voltage of power input: HY-DY10\'s power input of the power supply shall be 220VAC/50Hz. If 110VAC required please specify when placing order.
4. Others: A group of protection switches are also reserved for detection of water switch, fan switch,open-enclosure protection and so on.
Packing list:
1*HY-DY13 100W Co2 Laser Power Supply
Comments
Post a Comment